DONE IN ONE™

O’SHEET!™ With just one application you can remove moderate to light imperfections, polish to a high luster and protect the finish with our DONE IN ONE™ compound-polish-protectant! A time saver for the professional and easy enough to use for DIY enthusiast.

Features:

• Beige color
• Woodsy odor
• A ceramic SiO2 formula

Benefits:

• Correction-Polish-Protection with a single application
• Hologram-free results leave a mirror like finish
• Si02 infused formula protects paint for up to 6 months

Use for:

• Professional or DIY enthusiasts
• An easy and fast way to correct-polish-protect in 1 step
• Removes yellowing from older PPF coatings

How to use:

1. Read and understand SDS and all info on the label first. Do not apply Done in One™ in direct sunlight. Make sure paint is cool to touch. Wash and dry vehicle thoroughly.
2. Attach a clean medium-cut polishing pad to your machine.  You can lightly mist the pad with a detail spray or pad conditioner to prime it.
3. Add 3 to 4 pea-sized drops of Done in One™ to the face of your polishing pad.

Machine Polishing Process:

1. Start by following steps 1-3 above.
2. When using a rotary polisher, work the product at low to medium speeds. When using an Orbital/Dual-Action Polisher work on a section of about 2×2 feet. Set the machine to a medium-to-high speed and work the polish until it turns clear. Always treat one complete panel (e.g., hood, roof) at a time.
3. Because Done in One™ has a zero dwell time, immediately after polishing, wipe away the remaining residue using a clean, high-quality microfiber cloth. The exception to this would be if you plan to top it with a separate ceramic spray or additional sealant, then allow the base layer to cure for 2 to 4 hours

Hand Application & Working the Product:

1. Place 3 to 4 pea-sized drops of Done in One™ directly onto your applicator pad.
2. Focus on a small area, working in about 1×1 foot sections at a time using a cross hatch motion. Rub the product into the paint using firm, overlapping straight lines. Move up-and-down, then left-to-right. Use moderate to heavy hand pressure to agitate the light scratches and swirls.
3. Remove product and buff immediately. Do not let the product dry or laze over.
4. Wipe clean using a clean, dry microfiber towel to wipe away the residue immediately.
5. Check your finish. Repeat if deeper defects remain before moving to the next area.

• Tech Tip: Do not apply this product or unpainted plastic trims, rubber, or directly in the sun.  Protect the liquid from frost when storing.

Distinctive Details, Inc. assumes no liability for damages resulting from improper application.

NOT FOR SALE IN CALIFORNIA – FOR PROFESSIONAL USE ONLY – MADE IN USA

Order using these numbers:

32271 – 4oz

32273 – Quart (32 oz.) Carton Qty: 12